Removing Exposed Film; Rewinding A Partially Exposed Roll; Advancing Film; Removing And Replacing The 35Mm Camera Back - Polaroid 8035 Repair Manual

8K Series ProPalette Repair Manual

Removing Exposed Film

When you are finished exposing a roll of 35mm film, the camera will automatically
rewind the film. The message panel will then display "Out of Film." Open the front door
of the recorder, open the film door, and remove the film cassette. The film should be
completely rewound into the cassette unless the film leader option has been selected as
described on page 41.

Rewinding a Partially Exposed Roll

To rewind a partially exposed roll of film, press the Escape key to display the Change
Setup menu. Press the Down key until "Rewind Film" is displayed. Press the Select key.
The film will rewind, and the message panel will display "Out of Film" when done.
Remove the film.
Note: Do not try to reinstall a partially exposed roll of film.

Advancing Film

If you need to advance film (leave unexposed frames) during a session, press the Escape
key to display the Change Setup menu. Press the Down key until "Advance Film?" is
displayed. Press the Select key; the film will advance one frame. To advance the film by
more than one frame, repeat this sequence the desired number of times.
Note: This option is useful if a power failure occurs during an exposure.
Advance the film by one frame, then reshoot the image on the next frame.
Or, if you accidentally opened the film door when a partially exposed roll
was loaded, advance the film by a few frames to bypass the light-fogged
area of film.

Removing and Replacing the 35mm Camera Back

To remove the 35mm camera back:
1. Open the front cover of the recorder.
2. Move the locking lever to the unlocked ( ) position (Figure 2-41, left).
3. Carefully pull the camera back straight off (Figure 2-41, right). Replace the
lens cap, which is stored in the front cover, while the camera is not in use.
Figure 2-41. Removing and replacing the camera back
Hardware Operating Information
43