8K Series ProPalette Repair Manual
12. Wait for the ROM Monitor to indicate that the upload is complete (Figure
4-8).
13. To start the uploaded program, type g 0 and press Enter. (The command
requires a zero, not the letter "O," as shown in Figure 4-9.)
14. Follow the instructions on the screen to run the program or perform the
diagnostic test.
15. When the test or program is finished, press <alt X> and Y to exit ProComm
(Figure 4-10).
16. If you disabled the watchdog timer in step 2, re-enable it (page 54).
17. Reset the ProPalette by either shutting down the power or pressing the reset
button.
Figure 4-8. Screen indicating upload complete
Figure 4-9. Command g 0
Figure 4-10. Exit to DOS confirmation
92
Troubleshooting and Diagnostics