8K Series ProPalette Repair Manual
Note: When reinstalling the front plate, note that one corner does
not form a 90 degree angle. This corner matches a similar
corner on the light box. Slide the panel into the light box
and reach in from the access cutout to align the plate screw
holes with the screw holes in the light box. Be careful to
push on the plate and not on the filter wheel when doing
this.
Removal of the Filter Wheel
1. Remove the Front Bezel Assembly.
2. Remove the Camera Plate Assembly.
3. Remove the Access Panel.
4. Remove the Top Cover and Rear Panel Assembly.
5. Remove the CRT Assembly
6. Remove the Front Plate Assembly.
7. Remove two screws which hold the filter wheel blinder in place. (Figure 5-28)
8. Remove the e-ring holding the wheel on the shaft and lift off the filter wheel.
BLINDER
Installation of the Filter Wheel
Reverse the steps above.
E-RING
Figure 5-28. Removing the Filter Wheel
EDGE OF
FILTER
WHEEL MUST
BE BETWEEN
ARMS OF
WHEEL
POSITION
SENSOR
151
Parts Replacement