Removal Of The High Voltage Power Supply; Installation Of The High Voltage Power Supply - Polaroid 8035 Repair Manual

8K Series ProPalette Repair Manual
Note: Be sure the edge of the filter wheel is positioned between
the arms of the wheel position sensor when you place the
wheel back on its shaft. Also, after installing the e-ring and
the blinder, spin the wheel on the shaft to be certain it is not
binding anywhere.

Removal of the High Voltage Power Supply

1. Remove the Top Cover and Rear Panel Assembly.
2. Turn the unit on its side and identify and remove four screws which hold the
High Voltage Power Supply to the Pan Assembly. Use care since the power
supply will shift once the last screw is removed. (Figure 5-29)
3. Slide the power supply out from under the CRT.
4. Remove the connector from the power supply.
5. Disconnect the fuse holder.
6. Remove the large metal shield and disconnect the cables from the power
supply at their termination points.
7. The power supply is now free.
REMOVE FOUR
SCREWS HOLDING
POWER SUPPLY
Figure 5-29. Removing the High Voltage Power Supply

Installation of the High Voltage Power Supply

Reverse the steps in the removal procedure above.
FUSE HOLDER
152
Parts Replacement