Removal Of The Lcd Keypad Assembly; Installation Of The Lcd Keypad Assembly - Polaroid 8035 Repair Manual

8K Series ProPalette Repair Manual

Removal of the LCD Keypad Assembly

1. Remove the Front Bezel Assembly.
2. Remove two 6-19 x 3/8 self-tapping screws which secure the LCD Keypad to
the Front Bezel Assembly. (Figure 5-2)
3. Lift the keypad straight up and away from the front bezel.

Installation of the LCD Keypad Assembly

Reverse the steps above.
Note: New Keypad Assemblies have a protective film over the
LCD window. Be sure to peel this film off before installing
the unit. Also, when locating the Keypad Assembly on the
Front Bezel Assembly, "jiggle" it slightly before installing
the two screws to be sure it is properly seated. After
installing the screws, examine the front bezel to be sure that
the "fingers" are properly located in the slot of the bezel
and not hung up under the bezel.
LCD
INTERFACE
CABLE
Figure 5-2. Removing the LCD keypad
123
Parts Replacement
LCD KEYPAD
ASSEMBLY
#6-19 X 3/8
SELF-
TAPPING
SCREW S (3)