Polaroid 8035 Repair Manual page 135

8K Series ProPalette Repair Manual
3. Remove the Access Panel.
4. Slide the Top Cover and Rear Panel Assembly back to reveal the PC boards.
5. Drill out the heads of the two rivets which secure the Wheel Position Sensor
to the Front Panel. (Figure 5-13)
Caution: Be certain that all debris from the drilling is removed
6. Slide the sensor assembly off the shafts of the two rivets. The sensor is now
free of the front plate, but is still attached to the cable assembly which
terminates at the Digital PC Board. To completely remove the sensor and
cable, complete the installation procedure which follows.
from the unit. This includes debris that may be located at
the base of the front panel on the outside and debris that
may be located in the access panel area.
Figure 5-13. Removing the wheel position sensor
DRILL OUT
TWO RIVETS
135
Parts Replacement