Polaroid 8035 Repair Manual page 144

8K Series ProPalette Repair Manual
5. Carefully peel back the self-adhesive light box seal at the top right corner of
the Front Plate Assembly. Fold it back far enough to expose the cables under
it. (Figure 5-22)
6. Cut the tie wraps in the two areas where they hold the wiring cables to the top
of the light box assembly.
7. The stepper motor cable, the wheel position sensor cable, and the autoluma
board cable are laced together in a harness going to the electronics drawer.
Disconnect the first two from the digital PC board and the autoluma cable
from the analog PC board and pull the cables forward over the front plate.
8. Disconnect the High Voltage Power Supply Cables (2), the Yoke Assembly
Cable, and the Video Cable from the analog board.
DISCONNECT
CABLES
Figure 5-22. Preparing for Light Box Removal
144
TIE WRAPS
Parts Replacement
SELF
ADHESIVE
LIGHT SEAL