Removal Of The Front Bezel Assembly; Installation Of The Front Bezel Assembly - Polaroid 8035 Repair Manual

8K Series ProPalette Repair Manual

Removal of the Front Bezel Assembly

1. Open the front bezel door.
2. Remove the four 8-32 x 3/8 screws which secure the Front Bezel Assembly to
the Camera Plate Assembly. (Figure 5-1)
3. Pull the front bezel forward, lifting it slightly to release it from a lip on the
pan.
4. Carefully lift the bezel away from the main unit, to the extent allowed by the
cable.
5. Release the LCD Interface Cable from the LCD Keypad Assembly. (This is a
keyed connector which can only be installed one way.)
The Front Bezel Assembly is now free of the unit.

Installation of the Front Bezel Assembly

Reverse the steps above.
Note: Before installing the Front Bezel Assembly, slide the locking latch on
the camera plate to the left and turn the locking knob on the bezel to
the up position.
After sliding the front bezel onto the unit and before reinstalling the
four screws which hold it to the pan assembly, reach into the camera
opening to feel for the connector on the LCD Keypad Assembly. Be
sure it is firmly seated and has not been jarred loose. Also, verify that
the bezel and cover fit snugly together with no gaps in the area near
the bottom of the unit
Figure 5-1. Removing the front bezel assembly
FRONT BEZEL
ASSEMBLY
122
Parts Replacement
#8-32 X 3/8
SCREWS (4)