Installation Of The Digital Pc Board Assembly; Replacement Of The Camera Power Fuse; Removal Of The Analog Pc Board - Polaroid 8035 Repair Manual

8K Series ProPalette Repair Manual
REMOVE TWO
SCREWS TO
FREE
CONNECTOR
Figure 5-19. Removing the digital pc board assembly

Installation of the Digital PC Board Assembly

Reverse the steps above.

Replacement of the Camera Power Fuse

To replace the camera power fuse on the Digital PC Board, you must remove the Digital
Board as described in the previous section. Inspect the bayonet-type fuse, replace it if
necessary, and reinstall the Digital Board in the ProPalette.

Removal of the Analog PC Board

1. Remove the Top Cover and Rear Panel Assembly.
2. Remove the Electronics Drawer.
3. Disconnect the large connector between the digital and analog boards.
4. Remove the Digital PC Board.
5. Disconnect the remaining cables on the analog board. (These cables all
originate at the low voltage power supply. (Figure 5-20)
6. Remove seven screws holding the Analog PC Board in place: five at the heat
sink pad and two at the forward end, holding the board to the drawer
7. The board is now free of the drawer assembly.
REMOVE
FOUR
SCREWS
HOLDING
DIGITAL PC
BOARD
141
Parts Replacement