8K Series ProPalette Repair Manual
Removal of the Electronics Drawer
1. Remove the Top Cover and Rear Panel Assembly from the ProPalette.
2. Disconnect the following connectors from the PC boards (Figure 5-17):
Digital PC Board:
J12-LCD Interface
Cable
J13 -Camera Cable
J5 -Stepper Motor Cable
J6 -Wheel Position
Sensor Cable
3. Remove the screw holding the Digital PC Board to the top standoff and slide
the LCD cable tie wrap off the standoff.
4. Cut the tie wrap which secures the camera cable ferrule to the drawer and
move the cable aside.
ELECTRONICS
DRAWER
ASSEMBLY
5. Turn the unit on it side and remove two screws at the base securing the drawer
to the pan assembly (Figure 5-18). Turn the unit right side up again.
Analog PC Board:
J35 -Autoluma Board
Cable
J33 & J34 -High
Voltage Power Supply
Cables (2)
J37 -Yoke Assembly
Cable
J38 -Video
J12
J5
J6
J13
Figure 5-17. Removal of electronics drawer
139
Parts Replacement
Low Voltage Power Supply
Power switch cable