8K Series ProPalette Repair Manual
Removal/Installation of the LCD Interface Cable
1. Remove the Front Bezel Assembly.
2. Slide the Top Cover and Rear Panel Assembly back to reveal the PC boards.
3. Lay the new LCD Interface Cable next to the LCD cable in the ProPalette.
4. Disconnect the old LCD cable from the Digital PC Board.
5. Insert the connector of the new cable onto the PC board.
6. Using Figure 5-15 as a guide, remove the screw that secures the standoff
between the two pc boards.
7. Remove the old LCD cable by sliding the tie wrap off the standoff.
8. Secure the new cable to the standoff with a tie wrap.
Caution: Be sure the cable is pulled taut over the power supply
REMOVE
SCREW
SECURING
STANDOFF
Removal/Installation of the Camera Cable Assembly
1. Remove the Front Bezel Assembly.
2. Remove the Camera Plate Assembly.
3. Remove The Camera Cable (TEKA) Connector.
area. The cable should not be allowed to contact any
part of the power supply.
Figure 5-15. Freeing the LCD cable
137
Parts Replacement
SLIDE TIE
WRAP FREE
OF STANDOFF