8K Series ProPalette Repair Manual
Removal of the Power Switch
1. Remove the Front Bezel Assembly.
2. Using angled needle nose pliers, reach behind the switch and pull back each of
the four wire connectors from the contacts on the switch. (Figure 5-5)
3. Squeeze the tabs behind the switch and push the switch forward to free it from
the Camera Plate Assembly.
Installation of the Power Switch
1. Pull the four wires out slightly so they are protruding from the opening in the
Camera Plate Assembly.
2. Push the four wire connectors onto their respective contacts on the new
switch.
3. Push the switch and attached wires back through the opening until the tabs
snap behind the plate.
Figure 5-5. Removing the power switch
126
Parts Replacement
SQUEEZE
TABS TO
RELEASE
SWITCH