8K Series ProPalette Repair Manual
3. Trace the cable back to the Digital Board and disconnect it from the board.
4. Remove the connector/cable assembly from the unit by pulling the cable out
through the opening in the camera plate. This may require removal of tie-
wraps securing the cable.
Installation of the Camera Connector/Cable Assembly
Reverse the steps in the previous procedure.
Note: Make sure the connector is attached to the camera plate
with the cable-side facing downward as shown in (Figure
5-7). Replace any tie-wraps removed with the cable.
Removal of the Top Cover and Rear Panel Assembly
Note: For many of the removal procedures, it is not necessary to
completely remove the top cover from the ProPallete 8000.
After removing the securing hardware, simply slide the
cover back far enough to gain access to the particular area
of the unit you wish to service.
1. Turn the unit over, onto its top. (Figure 5-8)
2. Identify and remove ten 6-32 x ¼ Phillips Pan Head screws which secure the
top cover to the pan tracks.
#6-32 X ½
PHILLIPS PAN-
HEAD
SCREWS (3)
Figure 5-8. Removing the top cover
129
Parts Replacement
ACCESS
PANEL
#6-32 X ¼
PHILLIPS PAN-
HEAD
SCREWS (10)