Changing The Propalette Scsi Id - Polaroid 8035 Repair Manual

8K Series ProPalette Repair Manual
5. Press , then press
termination).
6. Press , then press
7. Press the Reset button on the back of ProPalette.

Changing the ProPalette SCSI ID

Caution: If two devices on a SCSI chain have the same SCSI ID
1. Turn off the computer and all other SCSI devices.
2. Turn on 8K Series ProPalette.
3. Press to display the Change Setup? menu on the message panel.
4. Press until SCSI ID? appears, then press
number.
5. Press to select an unused SCSI ID number.
Note: The SCSI host adapter is usually ID 0, and most internal
SCSI hard drives are ID 1. An internal SCSI CD-ROM
drive may be ID 3.
6. Press , then press
7. Press the Reset button on the back of 8K Series ProPalette.
or to highlight Yes (terminate) or No (turn off
twice.
number, neither will work correctly, and data may be
damaged when you turn on the devices.
The preset ProPalette SCSI ID is 4. If the SCSI ID of
any other device is 4, either change the SCSI ID of that
device (consult the device documentation) or of
ProPalette.
twice.
Hardware Operating Information
to display the current SCSI ID
29