Ip Auto Configuration; Subnet Mask - Minicom Smart CAT5 Switch 16 IP Operating Manual

.
SMART CAT5 SWITCH 16 IP

IP auto configuration

Choose between the 3 options.
None – no IP auto configuration. In this case type a static IP address in the
appropriate settings below.
DHCP - When selected, Smart 16 IP will contact a DHCP (Dynamic Host
Configuration Protocol) server in the local sub-net to obtain a valid IP address,
gateway address and net mask. Before you connect Smart 16 IP to your local sub-
net, complete the corresponding configuration of your DHCP server.
BOOTP - When selected, Smart 16 IP will contact a BOOTP (Bootstrap
Protocol) server in the local sub-net to obtain a valid IP address, gateway address
and net mask.
IP address
Static IP address in the usual dot notation.

Subnet mask

The net mask of the local network.
Gateway IP address
In case the Smart 16 IP should be accessible from networks other than the local
one, this IP address must be set to the local network router's IP address.
Primary DNS Server IP address
IP address of the primary Domain Name Server. This may be left empty, however
Smart 16 IP won't be able to perform name resolution.
Secondary DNS Server IP address
This address will be used in case the Primary DNS Server can't be contacted.
Primary Time Server
IP address of the primary NTP (Network Time Protocol) compliant timeserver.
Smart 16 IP will synchronize its own absolute time with the timeserver's one. This
is important for writing log entries and for the Dynamic DNS Service.
Secondary Time Server
This address will be used in case the Primary Time Server can't be contacted.
.
31