General Description; Specifications - Centurion R3 Installation Manual

General Description

General Description
The R3 & R5 rotary swing gate systems are designed to open and close swing gates. The CP75 controller
is capable of handling both single and double swing gates and offers many features to suit almost any
application.
Detailed specifications for the R3 & R5 motors are shown in the figure below and the table alongside.
The unit employs a battery driven DC motor for low duty domestic applications, which provides automatic
backup protection in the event of a power failure. The unit can also be fitted with a high duty power supply
in addition to the battery to allow for more frequent operation of the gate.
The R3 & R5 operators are fitted with an internal electronic limit switch system, which provides reliable
and accurate positioning of the gate. This system allows the operator to smoothly slow the gate down at
the fully open or closed positions.
A fail-safe and highly reliable collision sensing system is built into the controller, which will cause the
motor to stop while the gate is opening, and stop and reverse when closing if a gate is obstructed in any
way. (The collision sensitivity will be reduced during the endpoints of sinusoidal motion).
Gate movement is transmitted to the gate by means of articulated arms. The length of both the drive arm
and the connecting arm is easily adjusted to give maximum installation flexibility.

Specifications

Figure 1 Overall Dimensions
337mm 337mm
110mm
237mm
100mm
Page 8
220mm