Centurion R3 Installation Manual page 31

See Set-up Troubleshooting Guide
(
Selecting the Feature to Change
(This is the first of two steps in setting a Feature. This only SELECTS the feature to change).
30. To select the Feature to change, Press and hold the TEST button while monitoring L1.
31. L1 will flash once then go off, twice in short succession then go off, 3 times then go off, etc. Release
the TEST button when the number of flashes is the same as the Feature number to select.
Example 1:
To set the MODE OF OPERATION to CONDOMINIUM (That is Feature number 4, to a status of 2
according to table 2 on page 47) Press and hold the TEST button while monitoring L1:
The L1 light will flash once and pause,
At this moment release the TEST button to select Feature 4. L2 will turn off, and L1 will keep on
flashing 4 times and pausing to indicate that Feature 4 is selected
NOTE: The STATUS of the Feature is not changed yet, the feature has only been
selected to be changed!
32. If an incorrect Feature is selected, then remove and re-apply power and re-start from step 30. None of
the Feature settings will have been altered at this stage.
Changing the STATUS or COUNT value of a Feature.
33. To set the STATUS value of the Auto Close, Mode of operation, Collision Sensitivity, Positive Close
mode, Pre-flashing, or the Leaf delay Features:
Press and hold the TEST button while monitoring the STATUS light. The STATUS light will flash the
same as for selecting a Feature. (See Step 31) Release the TEST button when the number of flashes
is the same as the STATUS value required.
Example 1 (continued):
To set the MODE OF OPERATION to CONDOMINIUM:
After selecting the Feature, again press and hold the TEST button while monitoring the
STATUS light:
The L1 light will flash once and pause,
At this moment release the TEST button to give a STATUS value of 2. The mode of operation
has been changed to condominium.
NOTE: Only after setting the STATUS, would the mode of operation be changed to
reversing!
step 14 or 29)
then flash twice and pause....
then flash 3 times and pause....
then flash 4 times and pause....
then flash twice and pause.....
Page 31