Centurion R3 Installation Manual page 25

Twist anti-clockwise
to loosen.
Retract inner tube
completely
Twist clockwise until
ski-pole lock starts to tighten
Figure 17 Prepare Connecting Arm For Installation
until the ski-pole lock starts to tighten. Do not
over tighten, as that will make the final
adjustment more difficult.
14. Open the gate, and possibly swing the drive
arm slightly, until the connecting arm can be
fitted into the gate bracket using the clevis pin
(see Fig. 19)
15. Using the gate as a lever, slowly close the
gate to extend the connecting arm. When the
gate is completely closed, the hinge points
of the connecting and drive arms must be
in a straight line (see Fig. 22).
16. In a double leaf gate system, ensure that both
gates are correctly aligned in the closed
position.
17. Carefully unhook the connecting arm from the
gate bracket making sure it's length is not
altered. Hand tighten the connecting arm ski-
pole lock and reconnect it to the gate bracket.
18. Manually operate the gate leaf and check that it opens sufficiently.
If the gate opens too little, lengthen the drive arm by 10mm and readjust t he connecting arm by
restarting from step 14.
Inner tube
Outer tube
Apply each of the warning decals to both the
inward and outward faces of the gate frame.
Figure 18 Apply warning decals to gate
Connecting Arm
Figure 19 Fit Connecting Arm to Gate Bracket
Page 25
Clevis Pin
Gate Bracket
Bush
1
2