General Description - Centurion Vector2 Installation Manual

2. General description

The VECTOR2 operator has been designed to safely and cost-effectively automate a wide
variety of swing gates, from single light-domestic swing gates to heavy industrial double
swing gates.
The fail-safe and fully redundant position and Collision Detection system has been
designed and tested to set the standard in safety of operation and to provide an
unparalleled level of reliability and durability in operation.
The gate Travel Limits are managed by a sealed double-redundant opto-electronic system
that has been designed not only to ensure ultra-reliable operation, but also to ensure
precise position and trajectory control. This enables very accurate and reliable collision
detection to ensure safe operation even under trying conditions.
The VECTOR2 control card has been designed to be easy and intuitive to use with helpful
instructions on the status of the operation during and after the installation. It also has a
built-in diagnostic procedure that can verify every aspect of the control card on site.
Some of the advanced features offered by the VECTOR2 controller are:
Fully automated single button Limit Setup for single and double swing gates

Full graphics LCD display provides an intuitive user interface with built-in diagnostics to

speed up and simplify the installation process
Separate safety inputs for sensitive edges or beams on both the closing and opening

directions of the gate
Advanced closed-loop speed control to maintain safe and reliable operation on inclined

gates under windy conditions
Fully configurable gate Run Profiles

Selectable and adjustable Autoclose with pushbutton override

Pedestrian (Partial) opening with automatic closure

Free-exit input

Positive Close Mode

Multiple Modes of Operation

Solenoid lock drive output up to 2A

Holiday Lockout

A status LED output to indicate the gate status remotely

Pillar Light control

Leaf delay selectable for either gate leaf

Onboard CENTURION receiver with selective adding and deleting of remotes

Page 6