Important Safety Instructions; General Description - Centurion D10 Installation Manual

1. Introduction
This guide is designed specifically for installers who are familiar with
the installation of standard sliding gate motors, but do not know the
specifics of the D10 and D10 Turbo.
Always ensure that all the safety instructions described in the
installation manual are adhered to during and after the installation
process is completed.

2. Important Safety Instructions

Please do not proceed with the installation until you have
read and fully understand the Safety Instructions
included in your product packaging
The Safety Instructions are also available on
www.CentSys.com, and may also be obtained by
contacting Centurion Systems on +27 860 236 887
or +27 11 699 2400
3. Icons used in this guide
This icon indicates tips and other information that could be
useful during the installation
This icon denotes variations and other aspects that should be
considered during installation
This icon indicates warning, caution or attention! Please take
special note of critical aspects that MUST be adhered to in
order to prevent injury

4. General Description

The D10 is a heavy duty sliding gate operator designed to open and
close sliding gates. The D10 Turbo is perfectly suited for sites with
lighter gates requiring a high number of operations per day and very
fast opening and closing speeds, and can reach almost double the
speed of the standard D10. However, it is recommended that very
heavy gates are not operated at maximum speed, as the inertia
generated by heavier loads might prove detrimental to the gearbox at
such high speeds. A die-cast aluminium gearbox, coupled to a
powerful 24V DC motor and switch mode charger, make the D10 the
automatic choice for townhouse complexes and office parks. Gate
travel limits are managed by an opto-electronic system, comprising of
a gate-mounted origin magnet and an internal rotary encoder. This
system yields precise and repeatable control over gate position.
5. D10/D10 Turbo Identification
1
2
3
4
5
6
7
8
1. D10/D10 Turbo controller
2. Courtesy light fuse (3A F/B)
3. 2 x 12V 7.2Ah batteries
4. Gate-mounted origin marker
5. Origin marker bracket
6. Origin sensor (clip under
battery)
7. Lower cover
8. Foundation plate
9. Motor fuse (30A ATO)
10. D10/D10 Turbo charger
11. Manual Release handle
12. Lock cover
13. Encoder sensor
(clip behind charger)
9
10
11
12
13