Usb Hid Via 3656; Activate Usb Hid & Select Keyboard Type - CipherLab 1560 User Manual

1560 Series Barcode Scanner

2.5 USB HID VIA 3656

For USB HID, use the USB cable to connect the scanner via 3656 to the USB port of PC
and connect the power supply cord if necessary. Run any text editor on your computer,
and the scanned data will be transmitted to the computer.
HID Settings
Keyboard Type
Digits Layout
Capital Lock Type
Capital Lock State
Alphabets Transmission
Digits Transmission
Inter-Function Delay
Send "NR" to Host
2.5.1 ACTIVATE USB HID & SELECT KEYBOARD TYPE
When USB HID interface is activated, you will have to select a keyboard type to complete
this setting. By default, BT HID is activated on the scanner, and the keyboard type is set
to PCAT (US).
Activate USB HID & Select Keyboard Type ...
1) Read the label above to activate USB HID and select a keyboard type.
2) Read the "Decimal
of desired keyboard type.
3) Read the "Validate" label on the same page to complete this setting.
68
User Guide
Value" label on page 189. Refer to the table below for the number
Defaults
PCAT (US)
Normal
Normal
Off
Case-sensitive
Alphanumeric keypad
0 (ms)
Disable
Enter Setup