Quick Start - CipherLab 1560 User Manual

QUICK START

The configuration of the scanner can be done by reading the setup labels contained in
this manual or via the ScanMaster software. This section describes the procedure of
configuring the scanner by reading the setup barcodes and provides some examples for
demonstration.
Configuration Mode
1. Hold down the trigger about 2 seconds to turn on the scanner. It will respond with a long beep
and its LED will come on and off shortly.
2. Have the scanner read the "Enter Setup" label. It will respond with six beeps and its LED
indicator will become flashing red after reading the label.
3. Have the scanner read more setup barcodes... Most of the setup barcodes are normal labels.
The scanner will respond with two beeps (low-high tone). For special labels, it requires reading
more than one setup barcode to complete the setting.
4. Have the scanner read the "Update" or "Abort" label. It will respond with six beeps and its LED
indicator will become flashing red after reading the label.
5. The scanner will restart automatically upon reading the "Update" or "Abort" label. It will
respond with a long beep and its LED will come on and off shortly.
Note: Refer to Appendix II Host Serial Commands
by having the scanner read 3656-related setup labels or using serial commands.
for how to configure the 3656 stand
Update
7