Example - CipherLab 1560 User Manual

1560 Series Barcode Scanner

EXAMPLE

Without using the scanner to read the above setup labels for configuring the 3656 stand,
you may run HyperTerminal.exe on the host computer to send serial commands to 3656
via RS-232, USB Virtual COM or HID.
1) Connect the interface cable, RS-232 or USB, between 3656 and your computer.
2) Connect the power supply cord from 3656 to a proper power outlet.
The Communication LED will indicate when 3656 can accept serial commands after
initializing. Refer to the table below.
Communication LED
--- Blue,
solid
Red, Blue,
solid flashing
Red, Blue,
flashing flashing
If the output interface is USB Virtual COM or RS-232, run HyperTerminal.exe on
your computer. While the Communication LED on 3656 is purple (red with flashing
blue), type the serial command within three seconds.
If the output interface is USB HID, press the "NumLock" or "CapsLoack" key on
your keyboard 5 times within 3 seconds while the Communication LED on 3656 is
flashing red and blue. This will change the interface from USB HID to USB Virtual
COM and the Communication LED will become purple (red with flashing blue).
Then, run HyperTerminal.exe on your computer. While the Communication LED on
3656 is purple (red with flashing blue), type the serial command within three
seconds. After configuring via serial commands, the interface will be reset to USB
HID after re-connecting the power supply cord.
186
User Guide
Meaning
Initialize
Serial command mode with USB Virtual COM or RS-232: wait 3 seconds
for starting a serial command
Serial command mode with USB HID: wait 3 seconds for pressing
[NumLock] or [CapsLock] 5 times via keyboard
Enter Setup