CipherLab 1560 User Manual page 25

The example below shows how to set numeric parameters:
Steps Action
1 Power on the scanner...
2 Enter the Configuration Mode...
3 Read a Setup label...
For example,
Normal label
Normal label
Special label
Decimal label
or labels
4 Exit the Configuration Mode...
5 The scanner will automatically restart itself...
OR
User Feedback if Successful
The scanner will respond with a long beep
(high tone) and its LED indicator will
become solid red and go off quickly.
The scanner will respond with six beeps
(high-low tone repeats three times), and
its LED indicator will become flashing red.
The scanner will respond with two beeps
(low-high tone) if reading a normal label.
The scanner will respond with one short
beep if reading a special label such as
"Max. Length", indicating
requires reading more labels.
Read the "Decimal Value" label(s).
Refer to Appendix
System"
The scanner will respond with two beeps
(low-high tone) when the input values are
validated.
Same as for Enter the Configuration Mode.
Same as for Power on the scanner.
Update
Quick Start
the setup
IV "Decimal
13