Pressure Seal PS 100 Manual page 46

Symptom
Sealer/folder rollers not
rotating
Documents not folding
squarely
Corners of document folding
Possible Cause
Gear or sprocket loose on
shaft
Chain broken or connecting
link dislodged
Check fold plate installation
Check fold plate
settings
Check guides on infeed tray
Check alignment of first fold
plate only, using plain paper
Check that the fold rollers
can move freely in the
chassis slots
Ensure the snap levers are
in place
Adjust the infeed guide
Check installation of fold
plates
Check orientation of fold
plates
Page 41
Solution
Change gear or sprocket
Check link,
necessary or replace chain
Ensure the
correctly installed on all of the
fold plate stubs.
stop Measure the paper as shown in
appendix A and ensure settings
are as stated on both fold plates.
Check that
feeding the paper in squarely.
Adjust the fold plate setting for
V-fold, then process plain paper
to exaggerate any folding errors.
Ensure movement
restricted, file slots in chassis
slightly if required.
Check levers are resting on the
bearing housings correctly.
Adjust position of the infeed
guide by loosening the retaining
screws and moving carefully,
remembering to tighten screws
again once repositioned.
Ensure the
correctly installed on all of the
fold plate stubs.
If the fold plates are not aligned
with the fold rollers mis-folding
may occur.
reinstate if
fold plates are
the guides are
is not
fold plates are