Jam Detection And Document Counting Circuitry; Conveyor And Outfeed Sensors; Operator Controls; Batch Counter - Pressure Seal PS 100 Manual

Jam detection and document counting circuitry

Conveyor and outfeed sensors

These monitor the flow of paper and should a misfeed occur they immediately shut
down the PS100, minimising the risk of spoiled documents. The sensors also
provide input to the counters.

Operator Controls

Batch counter

There are two types of batch counter available. The standard counter indicates the
number of documents in the current batch (since it was last reset) and has a push
button reset. There is an optional counter available for the cumulative total, and this
may only be reset by a service engineer.

Illuminated power switch

The power switch is illuminated when the PS100 is connected to the mains supply.

Run switch

The run switch lights when:
• Documents are properly loaded on the feed table, and
• There are no mishandled documents in the PS100
When the run switch is lit:
• Momentarily pressing the run switch processes one document
• Pressing and holding the run switch for two seconds processes all loaded
documents

Stop switch

Pressing the stop switch stops the PS100 after the document currently being fed is
processed. You can stop the PS100 anytime while documents are processing
The stop switch flashes when there is an operating error. To clear an error
condition:
• Remove the lid from the PS100
• Clear any mishandled documents
When the top cover is replaced, the PS100 automatically resets the error condition.
Page 6
.