Document Feed System; Removing The Feed Roll And Paper Separator - Pressure Seal PS 100 Manual

Document feed system

This section shows you how to remove and replace the PS100's:
• Feed roll and paper separator
• Clutch

Removing the feed roll and paper separator

1. Press the PS100's power switch to the off position and then unplug the power
cord from the wall.
2. Remove the top cover, the first fold plate and the right side cover.
3. Remove the e-clip at either end of the shaft, inside the bearings. Move the shaft
outwards, towards the operator side, and loosen the two screws securing the
feed roller hub to the shaft.
4. Slide the coupling to the left, away from the clutch.
5. Lift the shaft from the machine.
When reinstalling the feed roll shaft, make sure the bearing is properly seated in the
side frame.
loosen retaining screws
and slide hub and feed
roller off shaft
retaining screws
Figure 12. Removing the feed roll and paper separator.
paper separator
remove retaining clip
slide feeder wheel shaft
Page 30