Electrical Systems; Removing The Cover Switch - Pressure Seal PS 100 Manual

Electrical system
This section shows you how to remove and replace the following electrical
components:
• Lid switch
• Infeed sensor
• Outfeed sensor
• Motor

Removing the cover switch

1. Press the PS100's power switch to the off position and then unplug the power
cord from the wall outlet.
2. Remove the top cover.
3. Remove the two countersunk screws that mount the cover switch to the operator
side cover, taking care not to lose the washers and nuts inside the cover, and
disconnect from the board after removing the cover to gain access.
To replace the cover switch, complete the steps of this procedure in reverse order.
Figure 16. Removing the cover switch.
remove securing screws
Page 35