Unpacking The Ps100; To Unpack The Ps100 - Pressure Seal PS 100 Manual

Unpacking the PS100

The PS100 is shipped fully assembled in a wooden crate. Although some variation
in packing is possible, the unit should arrive at the customer site as described
below.
Warning: The PS100 weighs 80 kg. Therefore, two people are required to lift the
PS100 from the crate's skid onto the work surface. Do not pick up the PS100 by
the infeed tray.

To unpack the PS100

1. Locate the crate immediately next to the location where the PS100 will be set up
and operated.
2. Remove the screws that secure the top of the crate to the base of the crate, and
then lift the top off the base.
3. Remove the four screws securing the transit plates to the base of the crate
(shown in the following diagram).
4. Using two people, lift the PS100 from the base and onto the work surface.
5. Remove the four screws and washers securing the transit plates to the PS100
and situate the PS100 as required.
Page 12