Document Sealing System; Removing The Sealer Chain - Pressure Seal PS 100 Manual

Document sealing system

This section shows you how to remove and adjust the PS200's:
• Sealer chain
• Sealer

Removing the sealer chain

The sealer sprocket drives the sealer chain on the sealer drive shaft. The chain
drives the sealing rollers.
1. Press the PS100's power switch to the off position and then unplug the power
cord from the wall outlet.
2. Remove the top cover and left side cover.
3. Using a flat blade screwdriver, remove the connecting link on the motor chain
and remove the chain. When replacing the link, remember it should always face
the direction of motion.
4. Loosen the grub screws securing both sprockets and remove sprockets and
chain as a single unit.
Figure 14. Removing the sealer chain.
Page 33