Inspecting The Ps100; Setting Up The Ps100 And Verifying Operation - Pressure Seal PS 100 Manual

Inspecting the PS100

1. Visually inspect the exterior of the PS100 for damage.
2. Remove the left and right (operator) sides covers and inspect all electrical
connections. Make sure none have come loose during shipping.
3. Replace the covers.
4. Power up the PS100. (See "powering up the PS100" in the operator manual for
detailed procedures.)
5. Press the run switch for a few seconds. Listen for any unusual noises (grinding,
clattering etc.). Troubleshoot if necessary.

Setting up the PS100 and verifying operation

1. Adjust the stacker to accommodate the mailers.
2. Remove the top cover and set up the folder. (See "Setting up the folder" in the
Operator Manual for detailed procedures.)
3. Load documents. (See "Loading documents" in the Operator Manual for detailed
procedures.)
4. Start up and test the PS100. (See "Starting up and testing the PS100" in the
Operator Manual for detailed procedures.) Verify the following:
• Straight folds. If the folds are not straight on the document, check the
document guides on the feed table are parallel.
Page 14