Removing The Operator Side Cover; Removing The Non-Operator Side Cover - Pressure Seal PS 100 Manual

Removing the right (operator) side cover
Removing the right side cover allows access to the clutch gear, clutch, fold roller
gears, sealing roller gears, circuit board and operator controls.
1. Press the PS100's power switch to the off position and then unplug the power
cord from the wall outlet.
2. Remove the top cover, infeed and outfeed covers.
3. Remove the two thumb screws located underneath the right side cover.
4. Remove the cover from the base, and lay it next to the PS100.
At this point the cover is still attached to the machine by the cable for the operator
controls. To completely remove the cover from the machine, disconnect the
connectors carefully from the circuit board.
To replace the right side cover, complete the steps of this procedure in reverse
order.
Removing the left (non-operator) side cover
Removing the left side cover allows access to the sprockets and chains.
1. Press the PS100's power switch to the off position and then unplug the power
cord from the wall outlet.
2. Remove the top cover, infeed cover, outfeed cover and tray.
3. Remove both the thumb screws located underneath left side cover. Set the
screws aside.
4. Remove the cover from the base, and lay it next to the PS100.
To replace the left side cover, complete the steps of this procedure in reverse order.
Page 29