Document Folding System; Removing The Fold Rollers - Pressure Seal PS 100 Manual

Document folding system

This section describes how to remove and replace the PS100's fold rollers

Removing the fold rollers

Typically, the fold rollers only require periodic cleaning to remove the build-up of
paper, dust, toner and paper coatings. However, extensive use over a long period
of time may eventually make roller replacement necessary.
1. Press the PS100's power switch to the off position and then unplug the power
cord from the wall outlet.
2. Remove the right and left side covers.
3. Remove both folding plates and then remove the top-folding roller.
4. Remove the chain-connecting link carefully with a flat blade screwdriver, and
then remove the chain. Loosen the two grub screws and remove the fold roller
sprocket.
5. Remove the springs from around the folding roller bearings.
6. Remove the E-clips and bearings from the ends of the three fold rollers.
7. Remove the folding rollers.
To replace the folding rollers, complete the steps of the procedure in reverse order.
Page 32