Reading Configuration Barcodes - Datalogic PowerScan M8500 Product Reference Manual

Configuration Using Code Symbols

Reading Configuration Barcodes

To configure your reader:
1. Read the instructions for the setting that you want to configure.
1. If needed, go to
2. Read the Enter Configuration code ONCE, available at the top of each page of con-
3. Modify the desired parameters in one or more sections, following the procedures given
4. Read the Exit and Save Configuration code ONCE, available at the top of each
Reference notes providing detailed information for the more complex parameters are given
in "References"
54
You must first enable your reader to read barcodes in order to use this
section. If you have not done this, go to
page 39
and complete the appropriate procedure.
Appendix F
you can use it during the device configuration.
figuration.
for each group.
page of configuration.
beginning on page 155.
with the hex-numeric table and bookmark it or print it so
Setup Procedures, starting on
PowerScan® M8500