PowerScan M8500 Setup
Fixed Desktop Use
For fixed desktop installation, use the adhesive strips or fixing screws (not provided)
according to your needs.
For mounting with adhesive strips:
1. Position the cradle onto the base by sliding it along the mounting tabs until aligned.
2. Carefully clean the adhesive strip seats of the base to remove any impurities that could
3. Remove the protective plastic from one side of the adhesive strips and stick them onto
4. Position the cables to be connected to the BC-80X0/C-8000 cradle along the dedi-
5. Remove the plastic from the other side of the strips and affix the base to the table.
6. If mounting the BC-80X0 cradle, insert the antenna in the appropriate hole on the
For mounting with screws:
1. Position the cables to be connected to the BC-80X0/C-8000 cradle along the dedi-
2. Position the base on the table and affix it by means of the screws (not provided).
3. Position the cradle on the base by sliding it along the mounting tabs until aligned.
4. If mounting the BC-80X0 cradle, insert the antenna in the appropriate hole on the
32
reduce adhesion.
the base surface.
cated channels, as shown in the figures below:
Horizontal Base
body of the cradle and screw it clockwise until tight.
cated channels, as shown in the figures below:
body of the cradle and screw it clockwise until tight.
Inclined Base
PowerScan® M8500