Datalogic PowerScan M8500 Product Reference Manual page 49

PowerScan M8500 Setup
6.
END of procedure.
For Host Master Network Layouts (see page 37), the network configuration parameters can
be changed through STAR-Link™ software running on the PC. Star-Link™ software can
be downloaded free from the web site: www.scanning.datalogic.com.
For BC-8060 Master Network Layouts (see page 38), the network configuration parameters
can be changed either through the Datalogic Aladdin™ configuration software running on
the PC or by reading the barcode selections in the Network section of this manual starting
on page 79. If using configuration barcodes, it is advised to completely configure the cradles
before reconfiguring the PowerScan
46
Read the desired Enable Network code.
After completing the BC-8060 cradle configuration and connections in
the network, you must reconfigure the PowerScan
the STAR-System™ procedure on page 43.
Enable RS-485 Master
Enable RS-485 Slave
®
M8500 reader (see below).
®
M8500 reader using
PowerScan® M8500