Using Multiple M-Series Readers With Same Cradle; Powerscan® M8500/Star-Modem™ In Stand-Alone Mode - Datalogic PowerScan M8500 Product Reference Manual

PowerScan M8500 Setup

Using Multiple M-Series Readers with Same Cradle

If you want to use several M-Series readers with the same BC-80X0 cradle, you must first
Bind the cradle with one of the readers (see previously described configuration procedure).
Successive readers
procedure substituting the
7.
END of procedure.
CAUTION
YOUR READER IS NOW READY TO READ BARCODES.
To change the defaults see
PowerScan
To configure a PowerScan
Stand-alone Mode, follow the procedure in
Setup"
6.
7.
END of procedure.
YOUR READER IS NOW READY TO READ BARCODES.
To change the defaults
42
can be associated with the same cradle by following the configuration
Bind
The green LED on the PowerScan
step 8. on page 41
the cradle. Complete
All readers associated with the same cradle must have different
addresses.
"Configuration Parameters"
®
M8500/STAR-Modem™ in Stand-Alone Mode
®
M8500 reader to communicate with STAR-Modem™ in
on page 40, substituting steps 6 and 7 with those below:
Read the code above and the four-digit address of the STAR-Modem™.
see"Configuration Parameters"
command with Join (see
Join
®
M8500 will blink: the reader is ready to be positioned onto
.
on page 53.
"PowerScan® M8500/BC-80X0 Stand-Alone
STAR-Modem™ Address
Exit and Save configuration
on page 53.
step 7. on page 41).
PowerScan® M8500