Wall Mounting
1. Remove the yellow caps and insert the two wall mounting lock hinges provided with
2. Position the cables to be connected to the BC-80X0/C-8000 cradle along the dedi-
3. Complete the procedure using one of the following two methods:
Product Reference Guide
your cradle.
cated channels (see figures on
If using the adhesive strips:
• Carefully clean the adhesive strip seats of the base to remove any impurities that
could reduce adhesion.
• Remove the protective plastic from one side of the adhesive strips and stick them
onto the base surface.
• Remove the plastic from the other side of the strips and affix the base to the wall as
indicated in the figure below.
If using the mounting screws:
• Using the mounting holes on the base as a pattern, mark the wall where you desire
to mount the BC-80X0/C-8000.
• Drill the appropriate size holes and insert the threaded dowels (not provided) into
the holes.
• Position the base on the wall as indicated in the figure below and affix it by means
of the screws (not provided).
PowerScan® M8500 Battery Maintenance
page
32.)
33