Host Configuration Strings - Datalogic PowerScan M8500 Product Reference Manual

In this section we provide a description of how to modify the device configuration using
serial strings sent from the Host.
The device configuration can be changed by receiving commands from the Host through
the serial interface. When this method is used, the programming sequence format is the
following:
Example:
Each configuration parameter setting removes the condition previously active for that
parameter.
Product Reference Guide

Host Configuration Strings

This method requires the RS-232 or USB-Com interface.
Command
$+
Character sequence in following tables
Enter configuration environment
Multiple command programming sequence:
$+ BG1 BH0 AC410132
Beeper tone 1
Beeper low intensity
Enter configuration environment
The device buffer can contain about 400 characters. If your program-
ming string goes over this value, you must split it into separate groups
and send each group after a delay of at least 3 seconds to give the reader
time to empty the buffer and interpret the commands.
$- CR
Carriage return character (0D Hex.)
Exit and Save configuration
$- CR
Carriage return character (0D Hex.)
Exit and save new configuration
Matrix 2/5 3 bars: no check digit,
variable length code from 1 to 32 characters
Appendix B
193