Removing The Inverter - EUROCOM D500P Service Manual

Removing the Inverter

1. Remove the battery (page 2 -
2 - 10), keyboard (page 2 - 11) CPU
2. Remove the rubber covers and screws
3. Run your finger around the middle of the frame to carefully unsnap the LCD front panel module
(Figure 2 - 25b).
4. Remove screw from the inverter, and disconnect cables
8
5. Lift the inverter off the LCD assembly
11
a.
1
6
5
c.
8
9
7), bay one device (page 2 - 8), hard disk assembly
(page 2 - 13), palm rest (page 2 -
- from the LCD (Figure 2 -
1 6
&
9
(Figure 2 - 25d).
b.
2
d.
3
4
10
(page 2 - 9), bay two device
17) and bottom case (page 2 -
25a).
7
from the rear of the inverter (Figure 2 -
10
7
11
Disassembly
Figure 2 - 25
LCD Removal
(page
Sequence
18).
a. Remove the screws.
from the back
b. Unsnap the
front panel from the
back.
25c).
c. Remove the screw
from the inverter.
d. Disconnect the ca-
bles and remove the
inverter.
7. LCD Front Panel
11. Inverter
• 7 Screws
Removing the Inverter 2 - 27
LCD