Tampering - Direct IP Network Camera Operation Manual

Tampering

Check the Tampering box to set up a tampering detection event. When a radical change is detected
in video (for example, the camera is moved, lens is blocked, etc), it considers it as an event.
 Sensitivity: Set the tampering sensitivity. The higher the number is, the more sensitive it is.
 Activation Time: Adjust the duration that tampering should last to be considered as a tampering
event. The camera will not consider any tampering as a tampering event if it lasts less than the
preset time.
 Use Ignoring Time: Set up the event ignoring time. The camera will not consider tampering
that occurs during the preset time span as an event.
 Event Action: Check the box for each action the camera is to take when it detects a tampering.
− Alarm Out: Check the box to trigger an alarm-output signal.
− Send Email: Check the box to send an email. Selecting Image Attachment attaches an event
detected image file (.JPG) to the email.
− Remote Callback: Check the box and select the remote systems to send a message (Not
supported for the WebGuard program).
− Audio Alarm: Check the box and select the audio file (.wav) to sound.
− FTP Upload: Check the box to upload images to an ftp server.
− Record: Check the box to record video
− Move PTZ to: Select the desired preset number that you want the camera to move to. You
must set preset locations in Remote Setup (Video – PTZ menu > Preset tab).
NOTE: You must properly configure the settings related to each event action when setting them
up to enable event actions. Refer to the Event Action setup.
.
Network Camera
57