Direct IP Network Camera Operation Manual page 58

Operation Manual
Check the Alarm In box to set up an alarm-in event. When the camera senses an input on the alarm
input connector, it considers it as an event.
 Title: Enter the alarm-in device's name.
 Type: Select the alarm-in type.
 Event Action: Check the box for each action the camera will take whenever it detects an alarm-in
event.
− Day & Night Mode: Check the box to disable the IR cut filter during the event detection.
Checking the box disables the Day & Night Mode feature set during the Video – Camera
setup. Selecting B&W Mode enables the black and white mode during the event detection.
When the event detection is expired, the IR cut filter is enabled and the black and white mode
is disabled.
− Alarm Out: Check the box to trigger an alarm-output signal.
− Send Email: Check the box to send an email. Selecting Image Attachment attaches an event
detected image file (.JPG) to the email.
− Remote Callback: Check the box and select the remote systems to send a message (Not
supported for the WebGuard program).
− Audio Alarm: Check the box and select the audio file (.wav) to sound.
− FTP Upload: Check the box to upload images to an ftp server.
− Record: Check the box to record video.
− Move PTZ to: Select the desired preset number that you want the camera to move to. You
must set preset locations in Remote Setup (Video – PTZ menu > Preset tab).
NOTE: You must properly configure the settings related to each event action when setting them
up to enable event actions. Refer to the Event Action setup.
52