Direct IP Network Camera Operation Manual page 62

Operation Manual
Check the Audio Detection box to set up an audio detection event. When the camera detects audio
during the preset activation time, it considers it as an event.
 Sensitivity: Set the audio sensitivity. The higher the number is, the more sensitive it is.
 Activation Time: Adjust the duration that audio should last to be considered as an audio-in event.
The camera will not consider any audio as an audio-in event if it lasts less than the preset time.
 Use Ignoring Time: Set up the event ignoring time. The camera will not consider audio that
occurs during the preset time span as an event.
 Audio Ignoring Interval: Select the audio ignoring dwell time from the drop-down list. The
camera will not log or send notifications of audio events occurring during the preset interval after
an audio is detected. You can control excessive event logging and remote notifications of audio
detection events by adjusting the audio ignoring dwell intervals.
 Event Action: Check the box for each action the camera is to take when it detects an audio-in
event.
− Alarm Out: Check the box to trigger an alarm-output signal.
− Send Email: Check the box to send an email. Selecting Image Attachment attaches an event
detected image file (.JPG) to the email.
− Remote Callback: Check the box and select the remote systems to send a message (Not
supported for the WebGuard program).
− FTP Upload: Check the box to upload images to an ftp server.
− Record: Check the box to record video
− Move PTZ to: Select the desired preset number that you want the camera to move to. You
must set preset locations in Remote Setup (Video – PTZ menu > Preset tab).
NOTE: You must properly configure the settings related to each event action when setting them
up to enable event actions. Refer to the Event Action setup.
56
.