Flexible Buttons - Panasonic KX-UTG200 Administrator's Manual

6.3 Flexible Buttons

Example: "[2346789]11|01[2-9]x.|[2-9]xxxxxxxxx"
•
If the dialed phone number is "21234567", "598765432" and so on when [Call Even If Dial Plan Does Not
Match] is set to [Yes], the call is made after the inter-digit timer expires.
•
If the dialed phone number is "21234567", "598765432" and so on when [Call Even If Dial Plan Does Not
Match] is set to [No], the call is denied after the inter-digit timer expires.
No Match:
Example: "[2346789]11|01[2-9]x.|[2-9]xxxxxxxxx"
•
If the dialed phone number is "0011", "1011" and so on when [Call Even If Dial Plan Does Not Match] is
set to [Yes], the call is made after the inter-digit timer expires.
•
If the dialed phone number is "0011", "1011" and so on when [Call Even If Dial Plan Does Not Match] is
set to [No], the call is denied.
6.3 Flexible Buttons
You can customize the flexible buttons on the unit. They can then be used to make or receive outside calls or
as feature buttons. These settings can be programmed either through the Web user interface (® see
4.6.3 Flexible Button Settings) or by configuration file programming (® see 5.5.6 Flexible Button
Settings).
Note
•
This feature may not be supported on your phone system.
The following types of flexible buttons are available:
Button
One-Touch Used to access a desired party or system
feature using the One-Touch Dialing feature.
BLF Used to show the current status of another
extension, call the extension and transfer
calls to it.
This button can also be used to perform
Directed Call Pickup (® see [Direct Call
Pickup] in 4.6.1.1 Call Control in the Web
user interface.
Note
292 Administrator Guide
Description
•
BLF (Busy Lamp Field) is an optional
feature and may not be supported on
your phone system.
•
It may be necessary to specify the
Resource List URI to use this feature,
depending on your phone system (®
see [Resource List URI] in
4.6.2.1 Call Control in the Web user
interface or "RESOURCELIST_URI" in
5.7.2 Per Line - Call Control
Settings in the configuration file).
Lamp Indication (KX-UTG200 only)
–
Off: The BLF extension is idle.
Red on: A corresponding BLF extension is
using the line.
Flashing green rapidly: The BLF extension
is receiving an incoming call.
Document Version 2014-04