4.6.2 Call Control [Line 1]–[Line n]
Default Value
Block Anonymous Call
Description
Value Range
Default Value
Do Not Disturb
Description
Value Range
Default Value
Return Code When DND
Description
Value Range
Default Value
Configuration File Reference
Return Code When Refuse
Description
Value Range
Default Value
Configuration File Reference
128
Administrator Guide
No
Selects whether to reject incoming calls that do not show the caller's
number.
•
Yes
•
No
No
Selects whether to enable the Do Not Disturb feature for incoming calls.
Note
•
If Do Not Disturb has been enabled on the server, the server
rejects incoming calls and the unit does not receive any calls,
even if you have selected [No] for this setting.
•
If you change this setting when [Feature Key
Synchronization] is set to [Yes], the change to this setting is
not immediately applied on this screen. In this case, reload the
screen to confirm that the change is applied.
•
Yes
•
No
No
Specifies the return code sent when the unit is in Do Not Disturb mode.
400–699
403
SIP_RESPONSE_CODE_DND (Page 281)
Specifies the return code sent when the unit refuses a call.
400–699
603
SIP_RESPONSE_CODE_CALL_REJECT (Page 281)
Document Version 2014-04