16) Affix the two supplied harness covers (bases) at the right rear of the machine with it aligned with the bottom line of the reader.
17) Affix the supplied harness cover (base) [1] at the back of the machine with it aligned with the bottom line of the reader.
18) Connect the connector of the repeating harness B [1] to the connector J317 [2] on the image processor PCB.
19) Secure the repeating harness B clamp [2].
- Supplied binding screw (M4x6) [1], 1pc.
[1]
F-2-62
[1]
F-2-63
[1]
[2]
F-2-64
[2]
[1]
F-2-65
Chapter 2
2-25