Canon iR2030 Series Service Manual page 116

Chapter 2
1) Pull the front side [1] of the drive belt in the direction of the arrow to move the contact sensor [2] to the vicinity of center.
2) Install the heater base [2].
- Screw [1], 1 pc.
3) Install the reader heater [3] on the header base [2].
- Screw [4], 1 pc.
2) Install the heater base [2] using a screw [1].
3) Install the reader heater [3] on the header base [2] using a screw [4]. Connect the connector [5] of the heater. Install the wire saddle [6] and route the cable [7].
4) Install the wire saddle [6] and route the cable [7].
5) Connect the connector [5] of the heater.
2-44
Do not touch the top surface of the contact sensor.
[1]
F-2-97
[1] [5]
[2]
F-2-98
[2]
[6] [7] [4]
[3]