Canon iR2030 Series Service Manual page 81

2.2.5 Installing the Toner Bottle
iR2022i / iR2025 / iR2030 / iR2018i
The image density may be slightly lower than usual on the first approx. 100
sheets printed after installation of the machine.
Therefore, perform the steps mentioned in <Going through the Developer
Idling Mode> (provided after step 6 in this section) before installing the
toner bottle.
1) Shake the toner bottle 5-6 times.
2) Open the front cover [1].
3) Insert the toner bottle.
4) While holding the toner bottle, pull the seal [1] to remove it.
F-2-24
[1]
F-2-25
F-2-26
[1]
F-2-27
5) Turn the toner cartridge in the direction of the arrow until it stops.
0017-5527
6) Close the front cover.
<Going through the Developer Idling Mode>
1) Plug the power cord into the outlet.
2) Open the front cover.
3) With the front cover open, turn on the main power switch.
4) When a message appears on the control panel display, press the following
keys to enter the service mode:
> 2 key > 8 key >
5) Select "#PRINT" using
6) Select "#PRINT SW" using
the following message is displayed:
Message: #PRINT SW 001 00000000
7) Press the following keys and confirm the message:
# key > 1 key > 4 key
Message: #PRINT SW 014 00000000
8) Position the cursor to Bit-1 (second from right) using
the 1 key, and then confirm the following message:
Message: #PRINT SW 014 00000010
9) Press the OK. Confirm that "SW 014" changes to "SW 015".
Message: #PRINT SW 015 00000000
10) Press the Reset key to exit the service mode.
11) Close the front cover. The machine will run in the developer idling mode
for about 1 minute.
12) When the machine stops, the idling mode ends.
Install, the toner cartridge following the above-mentioned procedure.
Chapter 2
F-2-28
F-2-29
or , and then press the OK.
or , and then press the OK. Confirm that
or , and press
2-9