Chapter 14
Display
Detail
code
Code
E540
0001
- Standard tray shift motor or finisher controller PCB failure
- Standard tray HP sensor failure
- Standard tray clock sensor failure
- Standard tray shift motor load failure
The standard tray was moved but the paper
surface was not detected.
0002
- Standard tray shift motor or finisher controller PCB failure
- Standard tray HP sensor failure
- Standard tray clock sensor failure
- Standard tray shift motor load failure
Cannot move (to the pickup position) within the
specified time.
0003
- Standard tray shift motor or finisher controller PCB failure
- Standard tray HP sensor failure
- Standard tray clock sensor failure
- Standard tray shift motor load failure
The standard tray was operated, but it did not
reach the sensor within 300 ms.
0005
- Standard tray shift motor or finisher controller PCB failure
- Standard tray HP sensor failure
- Standard tray clock sensor failure
- Standard tray shift motor load failure
The encoder clock signal was not detected two or
more times when the standard tray was operated
for 300 ms.
14-8
Main Cause/Symptom
Countermeasure
- Check the connector of the standard tray HP sensor.
- Check the connector of the standard tray clock sensor.
- Check the connector of the standard tray shift motor.
- Replace the standard tray HP sensor.
- Replace the standard tray clock sensor.
- Replace the standard tray shift motor.
- Replace the finisher controller PCB.
- Check the connector of the standard tray HP sensor.
- Check the connector of the standard tray clock sensor.
- Check the connector of the standard tray shift motor.
- Replace the standard tray HP sensor.
- Replace the standard tray clock sensor.
- Replace the standard tray shift motor.
- Replace the finisher controller PCB.
- Check the connector of the standard tray HP sensor.
- Check the connector of the standard tray clock sensor.
- Check the connector of the standard tray shift motor.
- Replace the standard tray HP sensor.
- Replace the standard tray clock sensor.
- Replace the standard tray shift motor.
- Replace the finisher controller PCB.
- Check the connector of the standard tray HP sensor.
- Check the connector of the standard tray clock sensor.
- Check the connector of the standard tray shift motor.
- Replace the standard tray HP sensor.
- Replace the standard tray clock sensor.
- Replace the standard tray shift motor.
- Replace the finisher controller PCB.