Canon iR2030 Series Service Manual page 95

8) Connect the connector [1] of the supplied repeating harness B to the connector [2] on the card reader.
9) Secure the repeating harness B clamp [4].
- supplied binding screw (M4x6)
10) Disconnect the shorting connector [5].
11) Secure the repeating harness B [1] with the edge saddle [2].
12) Remove the two blind seals [1] from the reader left cover.
Connect the repeating harness B's connector which is closer to
the clamp [6] to the connector of the card reader.
If the shorting connector [5] is not disconnected, a
malfunction or error can result.
MEMO:
The removed shorting connector is no longer necessary.
[6]
[1]
F-2-55
[1]
F-2-56
F-2-57
[4]
[3]
[2]
[5]
[2]
[1]
Chapter 2
2-23